The heating season is the best time to measure radon – indoor radon levels are usually at their highest during this period

 (0)


Radon measurements at workplaces

 

Employers in many European countries must check radon concentrations at workplaces, especially in basements and on ground floors in areas with more radon. We help you meet the legal requirements, from the measurement plan to the laboratory report.

 

What the rules are across Europe

 

EU Directive 2013/59/Euratom requires every member state to set a national reference level for radon at workplaces of, as a rule, no more than 300 Bq/m³ (annual average). Each country implements the directive in its own way, so deadlines, measurement durations and who may carry out the measurement differ. The overview below summarises the main requirements in selected countries. Always check the current national rules or the national authority before you rely on it.

 

Who must measure?

 

In general: employers with workplaces on the ground floor or in the basement in areas designated as having more radon, and employers in special workplaces such as caves, mines, underground facilities, spas, and water supply and treatment facilities.

 

Which areas and workplaces are covered depends on the country (see below). Even where there is no legal duty, the reference level of 300 Bq/m³ still applies in many countries, and only a measurement shows whether it is met.

 

 

France

The reference level is 300 Bq/m³ (annual average).

 

Employers must assess radon as an occupational risk and record it in their risk assessment document (document unique). The rules cover workplaces in basements and on ground floors in areas with significant radon potential (zones defined by the arrêté of 27 June 2018) and specific workplaces such as caves, mines and sewers (arrêté of 30 June 2021).

 

If the reference level may be exceeded, a measurement is needed: passive detectors for at least 2 months, preferably in winter, analysed by an accredited laboratory.

 

If the level is above 300 Bq/m³, the employer must reduce it (for example by ventilation or by sealing entry points) and re-measure. If it is still above, the results are sent to the IRSN and a dose assessment is carried out (based on 2,000 hours of work per year). If the dose could exceed 6 mSv per year, a radon zone must be delimited, a radiation protection adviser appointed, and dosimetry and enhanced health monitoring organised for the workers concerned.

 

Individual exposure assessments are kept for at least 10 years.

 

Spain

The reference level is 300 Bq/m³ (annual average), under Royal Decree 1029/2022.

 

Measurement is mandatory in underground workplaces (for example car parks open to the public, metro, mines, tunnels and caves), in workplaces that process or use groundwater (bottling plants, water treatment, spas), and in all activities on the ground floor or below ground in priority municipalities (Zone 2 of the Technical Building Code, as set out in the Nuclear Safety Council's Instruction IS-47).

 

Measurements use passive detectors analysed by a laboratory accredited to ISO 17025. For underground and groundwater workplaces, the measurement lasts one year (usually in 3-month periods). For other workplaces in priority municipalities, 3-month measurements are allowed, ideally between October and April.

 

If the level is above 300 Bq/m³, the employer must take corrective measures and re-measure. If it stays above 300 Bq/m³, the activity must be declared to the regional authority and entered in the register of work activities with exposure to natural radiation, and a radiation protection unit (UTPR) estimates the workers' doses. Workers and their representatives must be informed.

 

Portugal

The reference level is 300 Bq/m³ (annual average), under Decree-Law 108/2018.

 

Employers must keep radon as low as reasonably possible and below the reference level. Ground floors and basements are the priority for measurement, especially in areas of higher radon susceptibility shown in the national radon plan and on the map of the Portuguese Environment Agency (APA). Rooms occupied for fewer than 50 hours per year need no measurement.

 

Measurements use passive detectors for 3 months to 1 year (underground spaces: one full year) and must be carried out by accredited bodies. The APA guide gives minimum detector densities, for example one per 100 m² for small offices and one per 250 m² for open-plan offices.

 

If the level is above 300 Bq/m³, the employer must act immediately to reduce exposure, check the effect afterwards, and, if it stays above 300 Bq/m³, notify the APA and estimate whether the dose could exceed 6 mSv per year. Above 6 mSv per year, the planned-exposure rules apply.

 

Italy

The reference level for workplaces is 300 Bq/m³ (annual average), under Legislative Decree 101/2020.

 

Measurement is required in underground workplaces, in ground-floor and basement workplaces in the priority areas identified by the regions, in thermal establishments, and in specific activities listed in the national radon action plan (for example water treatment plants with open tanks, mineral water bottling plants and hydroelectric power plants).

 

The annual average must be determined by a recognised dosimetry service. Some rooms are exempt, such as bathrooms, changing rooms, corridors, technical rooms and rooms occupied for fewer than 100 hours per year. 

 

If the level is above 300 Bq/m³, corrective measures must be designed by a qualified radon remediation expert and their effect checked with a new measurement. If the level stays above 300 Bq/m³, a radiation protection expert assesses the workers' doses against 6 mSv per year. The employer must notify the competent authorities and keep the measurement reports in the workplace risk assessment document (DVR).

 

Germany and Austria

Specific rules apply in both countries. See our German-language pages for employers in Germany and in Austria.

 

Other countries

Rules for other European countries follow the same EU framework but differ in detail. Contact us for the requirements that apply to your country and your workplace.

 

 

Typical steps if the reference level is exceeded

 

  1. Take measures to reduce radon (ventilation, sealing entry points, sub-slab extraction, changes to room use or working time).
  2. Check the effect with a follow-up measurement.
  3. If the level is still above the reference level, notify the competent authority and assess the workers' dose.
  4. If the dose could exceed 6 mSv per year, occupational radiation protection rules apply.

 

How are the measurements carried out?

 

We measure with passive Radtrak³® detectors that stay in the chosen rooms for the period required by your national rules (from 2–3 months up to 12 months). Place them away from doors, windows, drafts, direct sunlight and heat sources, and carry on working as usual.

A screening measurement with an active monitor (e.g. RadonEye) is useful for a quick first look, but it does not replace a measurement by an authorised or accredited provider.

 

 

Who carries out the measurements?

 

The detectors are analysed by Radonova Laboratories AB (Uppsala, Sweden), a laboratory accredited to ISO/IEC 17025. Radonova is on the official lists of recognised radon measurement laboratories in Germany, Austria, France, Spain, Portugal, Slovenia, Norway and Sweden. RadonBlue is a distributor of Radonova detectors: we prepare the measurement plan, supply the detectors with instructions, arrange their return to the laboratory and explain the results.

 

If the values are elevated and a dose assessment is needed, we help you with the next steps. The assessment itself is carried out by a body authorised in your country.

 

 

How do we work together?

 

  1. You send us the basic details: the country and address, the number and type of workrooms on the ground floor and in the basement, and a floor plan if possible.   
  2. We prepare a quote and a measurement plan: how many detectors you need and where to place them.
  3. We deliver the detectors with placement instructions.
  4. After the measurement, you return the detectors. You receive the laboratory report and our explanation. If needed, we advise on next steps and the follow-up measurement.

 

 

Price

 

€42 per detector, including laboratory analysis, the report and a basic explanation of the results. For a larger number of rooms or sites we prepare a special quote.